I have essentially all the parts printed and about to be painted as well as the electronics ready to go, but I wanted to make sure my pieces are the correct size.
The trigger seemed a little to thin for the slot created by joining the two grips pieces. I know of course there should be some room to allow movement of the trigger. Yet if the free space isn’t supposed to be that large, I was planning on adjusting the width of the trigger and reprinting.
Could someone let me know if I should reprint a wider trigger?


Thank you! I’ll probably stick with your thickness since the rest of the parts fit perfect.
That's the right fit. If you want to scale it up in thickness, be my guest! Let me know if it works. The increase in thickness might make it more difficult to install the left grip without loosening the left dial.