Ok, thanks. Yeah, the tree supports are newer (in Cura at least) and in my experience, they have been easier to remove, so I was going to continue using them.
I've never used tree supports on my machine, just the standard "Rectilinear" or "Grid" support pattern. Either way, make sure you print it on the right side, with the smaller hole on the bed.
Ok, thanks. Yeah, the tree supports are newer (in Cura at least) and in my experience, they have been easier to remove, so I was going to continue using them.
I've never used tree supports on my machine, just the standard "Rectilinear" or "Grid" support pattern. Either way, make sure you print it on the right side, with the smaller hole on the bed.
Nevermind, I changed a setting and tried again and it added more supports.